Skip to content
View in the app

A better way to browse. Learn more.

BenLotus

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

How to Properly Recalibrate Your Battery

Featured Replies

  • Author
On 5/31/2020 at 5:03 PM, GCatipay said:

baka dina mag on ang phone. haha

 

Yown lang haha

"Don’t wait until your phone gets close to a 0% battery charge until you recharge it, advises Cadex’s Bradshaw. Full discharges wear out the battery sooner than do partial discharges. Bradshaw recommends that you wait until your phone gets down to around a 35% or 40% charge and then plug it into a charger. That will help preserve the capacity of the battery. You should also keep your phone cool, as higher temperatures accelerate the loss of battery capacity. Pro tip: Take off your phone’s case before you charge it." 
Kaya kung mapapansin nyo mas mataas yung chance na uminit yung phone kapag galing sa lower percentage, Pero sa ROG PHONE 2 ko, ginagawa ko hindi ko siya hinahayaang bumaba ng 20%, kaya makunat parin battery ko, And also, mapapansin nyo rin na yung ibang phone nag ii-stop magcharge due to high temperature(feature ng mga bagong phone). Lithium-ion operates safely within the designated operating voltages; however, the battery becomes unstable if inadvertently charged to a higher than specified voltage. Prolonged charging above 4.30V on a Li-ion designed for 4.20V/cell will plate metallic lithium on the anode. The cathode material becomes an oxidizing agent, loses stability and produces carbon dioxide (CO2). The cell pressure rises and if the charge is allowed to continue, the current interrupt device (CID) responsible for cell safety disconnects at 1,000–1,380kPa (145–200psi). Should the pressure rise further, the safety membrane on some Li-ion bursts open at about 3,450kPa (500psi) and the cell might eventually vent with flame. And lastly my own advice kung gusto niyo humina consumption sa battery niyo, use dark themes(wallpaper/darkmode/nightmode), check and turn off unnecessary  Start up applications, disable location, at wag masyado iexpose sa maiinit na lugar yung phone(lalo na kung nagge-games) yun lang po. this is my own opinyon and some research hehe 

 

  • Author
21 hours ago, admin001 said:

Yan favorite ko.

 

Anu po ito?

  • Author
20 hours ago, sukram22 said:

Nice info...thanks for sharing ?

Walang anuman

  • Author
34 minutes ago, Chuck said:

"Don’t wait until your phone gets close to a 0% battery charge until you recharge it, advises Cadex’s Bradshaw. Full discharges wear out the battery sooner than do partial discharges. Bradshaw recommends that you wait until your phone gets down to around a 35% or 40% charge and then plug it into a charger. That will help preserve the capacity of the battery. You should also keep your phone cool, as higher temperatures accelerate the loss of battery capacity. Pro tip: Take off your phone’s case before you charge it." 
Kaya kung mapapansin nyo mas mataas yung chance na uminit yung phone kapag galing sa lower percentage, Pero sa ROG PHONE 2 ko, ginagawa ko hindi ko siya hinahayaang bumaba ng 20%, kaya makunat parin battery ko, And also, mapapansin nyo rin na yung ibang phone nag ii-stop magcharge due to high temperature(feature ng mga bagong phone). Lithium-ion operates safely within the designated operating voltages; however, the battery becomes unstable if inadvertently charged to a higher than specified voltage. Prolonged charging above 4.30V on a Li-ion designed for 4.20V/cell will plate metallic lithium on the anode. The cathode material becomes an oxidizing agent, loses stability and produces carbon dioxide (CO2). The cell pressure rises and if the charge is allowed to continue, the current interrupt device (CID) responsible for cell safety disconnects at 1,000–1,380kPa (145–200psi). Should the pressure rise further, the safety membrane on some Li-ion bursts open at about 3,450kPa (500psi) and the cell might eventually vent with flame. And lastly my own advice kung gusto niyo humina consumption sa battery niyo, use dark themes(wallpaper/darkmode/nightmode), check and turn off unnecessary  Start up applications, disable location, at wag masyado iexpose sa maiinit na lugar yung phone(lalo na kung nagge-games) yun lang po. this is my own opinyon and some research hehe 

 

Okay Lang discharge if bagong bili ganun naman Kasi pag bagong bili ilowbat muna ng sobra tapos punoin sa 100

 

36 minutes ago, Chuck said:

"Don’t wait until your phone gets close to a 0% battery charge until you recharge it, advises Cadex’s Bradshaw. Full discharges wear out the battery sooner than do partial discharges. Bradshaw recommends that you wait until your phone gets down to around a 35% or 40% charge and then plug it into a charger. That will help preserve the capacity of the battery. You should also keep your phone cool, as higher temperatures accelerate the loss of battery capacity. Pro tip: Take off your phone’s case before you charge it." 
Kaya kung mapapansin nyo mas mataas yung chance na uminit yung phone kapag galing sa lower percentage, Pero sa ROG PHONE 2 ko, ginagawa ko hindi ko siya hinahayaang bumaba ng 20%, kaya makunat parin battery ko, And also, mapapansin nyo rin na yung ibang phone nag ii-stop magcharge due to high temperature(feature ng mga bagong phone). Lithium-ion operates safely within the designated operating voltages; however, the battery becomes unstable if inadvertently charged to a higher than specified voltage. Prolonged charging above 4.30V on a Li-ion designed for 4.20V/cell will plate metallic lithium on the anode. The cathode material becomes an oxidizing agent, loses stability and produces carbon dioxide (CO2). The cell pressure rises and if the charge is allowed to continue, the current interrupt device (CID) responsible for cell safety disconnects at 1,000–1,380kPa (145–200psi). Should the pressure rise further, the safety membrane on some Li-ion bursts open at about 3,450kPa (500psi) and the cell might eventually vent with flame. And lastly my own advice kung gusto niyo humina consumption sa battery niyo, use dark themes(wallpaper/darkmode/nightmode), check and turn off unnecessary  Start up applications, disable location, at wag masyado iexpose sa maiinit na lugar yung phone(lalo na kung nagge-games) yun lang po. this is my own opinyon and some research hehe 

 

Yung sinabe mo na use dark theme is for AMOLED na cp. Akin di naman AMOLED pero umaabot naman sa 13hours fb,YouTube at games.  Tsaka pag ako mag charge di ko pinupuno 15% tapos hanggang 97% tsaka ko tatanggalin. Tapos pag chinarge ko naka off hinde naka on mabilis din ito mag charge siguro mga 1hour lang puno at Isa pa supported itong cp ko Ng 5v na charger

  • Author
40 minutes ago, Chuck said:

"Don’t wait until your phone gets close to a 0% battery charge until you recharge it, advises Cadex’s Bradshaw. Full discharges wear out the battery sooner than do partial discharges. Bradshaw recommends that you wait until your phone gets down to around a 35% or 40% charge and then plug it into a charger. That will help preserve the capacity of the battery. You should also keep your phone cool, as higher temperatures accelerate the loss of battery capacity. Pro tip: Take off your phone’s case before you charge it." 
Kaya kung mapapansin nyo mas mataas yung chance na uminit yung phone kapag galing sa lower percentage, Pero sa ROG PHONE 2 ko, ginagawa ko hindi ko siya hinahayaang bumaba ng 20%, kaya makunat parin battery ko, And also, mapapansin nyo rin na yung ibang phone nag ii-stop magcharge due to high temperature(feature ng mga bagong phone). Lithium-ion operates safely within the designated operating voltages; however, the battery becomes unstable if inadvertently charged to a higher than specified voltage. Prolonged charging above 4.30V on a Li-ion designed for 4.20V/cell will plate metallic lithium on the anode. The cathode material becomes an oxidizing agent, loses stability and produces carbon dioxide (CO2). The cell pressure rises and if the charge is allowed to continue, the current interrupt device (CID) responsible for cell safety disconnects at 1,000–1,380kPa (145–200psi). Should the pressure rise further, the safety membrane on some Li-ion bursts open at about 3,450kPa (500psi) and the cell might eventually vent with flame. And lastly my own advice kung gusto niyo humina consumption sa battery niyo, use dark themes(wallpaper/darkmode/nightmode), check and turn off unnecessary  Start up applications, disable location, at wag masyado iexpose sa maiinit na lugar yung phone(lalo na kung nagge-games) yun lang po. this is my own opinyon and some research hehe 

 

Ginagawa ko pag nag internet ako naka airplane mode tapos naka on WiFi at isang process or Isa lang nirurun ko na application kaya tumatagal saaken kaya Ang Ganda talaga nitong phone na binili saaken 12nanometer siya tipid sa power.

Tsaka nagimprove yung processor Ng mediatek p70 at p60 sobrang ayos.

  • Author
Just now, Nearsteal said:

Heheheh. Try koto kpag nagloko na bat ko.

Wag na po alagaan mo mabuti yan para di masirap kakatry ko nga lang nito e kagabe kaya ito Ang tagal malowbat working talaga .. 

20 minutes ago, alexa_g said:

Anu po ito?

Wrong thread. Misclick lang. Sa isang thread mo na dapat yan.

  • Author
3 minutes ago, admin001 said:

Wrong thread. Misclick lang. Sa isang thread mo na dapat yan.

Ahh okay po.

1 hour ago, alexa_g said:

Ginagawa ko pag nag internet ako naka airplane mode tapos naka on WiFi at isang process or Isa lang nirurun ko na application kaya tumatagal saaken kaya Ang Ganda talaga nitong phone na binili saaken 12nanometer siya tipid sa power.

Tsaka nagimprove yung processor Ng mediatek p70 at p60 sobrang ayos.

oo maganda 12nm, pero mas mababa power consumption and more speed yung 7nm haha 7nm kasi rog, problema lang heat prone sya, kaya need talaga cooler, pero kung ginagamit mo sa mga lugar na airconditioned or hindi mainit hindi siya tataas ng 37°C 

  • Author
2 minutes ago, Chuck said:

oo maganda 12nm, pero mas mababa power consumption and more speed yung 7nm haha 7nm kasi rog, problema lang heat prone sya, kaya need talaga cooler, pero kung ginagamit mo sa mga lugar na airconditioned or hindi mainit hindi siya tataas ng 37°C 

Mahal Kasi Niyan haha.

  • Author
2 minutes ago, Chuck said:

oo maganda 12nm, pero mas mababa power consumption and more speed yung 7nm haha 7nm kasi rog, problema lang heat prone sya, kaya need talaga cooler, pero kung ginagamit mo sa mga lugar na airconditioned or hindi mainit hindi siya tataas ng 37°C 

Kagaya din siya Ng mga laptop na halimaw Ang specs kailangan NASA hinde mainit na Lugar.

bumaba na nga ng almost 20% price e, pero panget daw mga recent lumabas, madami problema, tsaka auto shutdown tapos hindi na masisindi. buti first batch akin lol

  • Author
1 minute ago, Chuck said:

bumaba na nga ng almost 20% price e, pero panget daw mga recent lumabas, madami problema, tsaka auto shutdown tapos hindi na masisindi. buti first batch akin lol

Hirap Niyan dun tayo sa mid range Ang importante nagagamit pang call at tawag yun Kasi Ang Dahilan bat nag pabili ako 

  • Author
2 minutes ago, aljon said:

tyty lots

Opo cge

Create an account or sign in to comment

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.